Stainless Steel Strip in Coil

 

Stainless Steel Slit Coils -

Surface Finishes, Edge Conditions, Coil Diameters and Tolerances
Surface finishes: 1D (old designation IIa) hot rolled, softened, descaled
2B (old designation IIIc) cold rolled, softened, descaled, pinch passed
2R (old designation IIId) cold rolled, bright annealed
2G (old designation IV)
2J (old designation IV)

Surface protection: Paper interleaving
Adhesive plastic foils from 50 - 120 microns
Deep drawing plastic foil

Edge condition: Slit edges
Prepared edges possible for size range from 6 x 0,5 mm to 100 x 6,00 mm
either burr smoothened by rolling the edges
or burr removed by shaving the edges

Coil diameters: inner diameter: 300 or 400 or 508 or 610 mm
outer diameter: as per your request, however max. 1600 mm

Width tolerance: acc. to EN 10259, DIN 59382 (please ask for closer tolerances if needed)
Thickness tolerance: acc. to EN 10259, DIN 59382, DIN 59381 (please aks for closer tolerances if needed)

 

Listed below is a selection of the grades we offer and the dimension range. We also offer addition grade so please call us if you can not see what you are looking for.

 

Dimensions / Materiel No. / Surface

     

Grade 
 AISI          W.Nr. 

      

430        

1.4016

      

430Mo  

 1.4113 

      

430Ti     

430Nb     

1.4510

1.4511

      

304       304 L     

1.4301

1.4307 

      

321        

1.4541 

      

316        
316L      

1.4401

1.4404

      

316Ti    

1.4571

      

 

Annealed, Half Hard or Hard